-
July 29th, 2002, 01:26 AM
#1
Inactive Member
I've got my dyno session coming up next Saturday. Before then, I will probably be installing a new set of RC 310cc injectors and disconnecting the TPS wire for my map mod.
Is it difficult to tune the fuel with injectors that large and no piggyback computers?
Do I need to get a restrictor for my Cartech 20005 to use the 310cc injectors?
While I'm on the dyno, besides playing with the needle valve on the Cartech to adjust my rise rate, what else should I look to adjust? Oh, I will be using their A/F meter.
-
July 29th, 2002, 02:33 AM
#2
Inactive Member
If still 6psi boost, don't use the cartech restrictor. It reacts faster without it.
I have to restrict it a little at 10psi, but not as restriced as the included restrictor.
-
July 29th, 2002, 06:44 PM
#3
Inactive Member
Where are you getting your dyno tune done?
-
July 29th, 2002, 07:51 PM
#4
Inactive Member
I have 9 psi (using Jim's pulley).
I am getting my dyno done at Engineuity. I went there once. . . it's about 30 minutes from La Jolla. I'll get clearer directions closer to Saturday.
-
July 29th, 2002, 10:04 PM
#5
Inactive Member
Send me a message or post up the info, I'd be interested in talking to them, or perhaps going over there too.
-
July 29th, 2002, 10:40 PM
#6
Inactive Member
Engineuity
619-336-1666
$60/hr
I'll be there Saturday morning right when they open for my 1 hr tuning session.
So will my friend in his 95 GST (just hp runs).
<font color="#a62a2a" size="1">[ July 29, 2002 07:42 PM: Message edited by: 217gsr ]</font>
-
August 4th, 2002, 01:11 AM
#7
Inactive Member
-
August 4th, 2002, 04:17 PM
#8
Inactive Member
They got me to drive all the way down to National City. . . and about an hour after I got there, I find out that the only guy who's qualified to operate the dyno is going to the track.
They told me to call them on Tuesday morning to see if they can squeeze me and my friend in on Tuesday afternoon.
The good thing about this is that I finally received my Cartech restrictor in the mail on Saturday. So I've got my 310cc injectors installed. ATleast I can tune with them.
-
August 4th, 2002, 04:25 PM
#9
Inactive Member
217gsr: Do you know of any dyno shops around miramar?
-
August 4th, 2002, 04:32 PM
#10
Inactive Member
Group 5. You have to call the shop on Dowdy to arrange a time. Then the dyno takes place at the old location (on Miramar, about a block away, where AEBS is now). They charge $100/hr.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks